A comprehensive pressure transducer kit with software for misfire detection.

iEA Intelligent Engine Analyzer Kit (EMI1030)

Camshaft timing off by one tooth?

That’s a very difficult challenge that will take hours of your time to prove. What if we told you that you could tell if the camshaft timing is off by as little as one tooth, in as little as five minutes. You would think we were CRAZY…. Well we aren’t! Our iEA - Intelligent Engine Analyzer uses advanced technology to check the pressure changes in the cylinders THROUGH THE SPARK PLUG HOLE!

INCREDIBLE? We think so.

Got a random misfire code, miss-identified misfire code, or no code at all, and the vehicle is misfiring? Another very difficult challenge that will take hours of your time to figure out. Our iEA shows you which cylinder or cylinders are missing through the exhaust tailpipe and then checks the mechanical condition of the cylinder through the spark plug hole in just minutes! ATS’ revolutionary iEA software automatically identifies problems and alerts the technician; saving hours of diagnostic time.

View large, colorful, razor sharp waveforms on your hi-res PC display. No laptop? No problem. We’ll load the iEA onto a customized, shop-tough laptop, and ship you the works, ready to roll. Just fire it up and go.

Just look what the iEA can do for You!

► Quickly identifies camshaft timing problems through the spark plug hole.

► Quickly identifies misfiring cylinders from the exhaust tail pipe.

► Finds problem cylinders and identifies them quickly.

► Misfire counters provide information on which cylinders misfired and counts

 how many times the misfire occurred.

► Will alert you to a bank misfire, random misfire, or individual misfire.

► Checks cranking, intake and exhaust pressure pulsation confirming mechanical condition of engine quickly.

► Checks restricted exhaust system.

► Checks ignition timing.

► Chosen one of the TOP 20 TOOLS of 2008 by Motor Magazine and one of the TOP 10 TOOLS of 2008 by Undercar Digest!

► Converts pressure transducer voltage to actual pressure or vacuum readings

► Powers up and reads up to four Pressure Transducers at one time.

► Can be used in conjunction with all ATS diagnostic equipment.

► Free software updates!

► Free technical support!

System Requirements:

► Runs on most Intel or AMD Processor Windows based PC with type A USB 2.0 port.

Will NOT run on the Microsoft Surface Pro X ARM64-based PC with the Microsoft SQ1 processor.

► Windows 7 Service Pack 1 through Windows 11 operating systems including Windows 11 tablets

(Windows RT tablets are not supported)