EScope Limited Download and Installation of latest version - Rev 1.04:

Checking your software version:
To see what version you are currently using load your EScope Limited software, click on the "Help" tab and then click the "About" text in the upper left hand corner of your screen.

The EScope Limited program will only run if you have the ATS EScope Limited hardware.

  • Download http://www.automotivetestsolutions.com/download/EScopeLTDInstall.zip (~32MB) to your desktop.
  • Double-click on the downloaded file on your desktop to view the zipped contents.
  • Double-click on Setup (Application) to install the EScope Limited. If the installer asks you if it is OK to uninstall the existing version allow it to do so and then run the Setup again to install the new version.
  • Besides the requirement for having the EScope Limited interface hardware connected to your computer you must also have the proper DAQ driver installed to use it.  See "Driver Download" at the bottom of this page for driver details.

Revision History (most recent version can be downloaded above)

  • 9/23/2007: Rev 1.04:
    • Added smoothing routine to Measure & Deep Rec.
    • Adding offset to Mark Cylinders for pressure transducer measurements.
    • Modified Deep record save to warn if file saving to already exists.
  • 5/24/2007: Rev 1.03:
    • Fixed problem where Demo Mode would automatically get selected at startup or auto-restart if DAQ board was not seen. Pop-up will now allow user to see error and re-start or select demo mode.
    • Changed Mark Cylinders to be offset -25% of one division for pressure marking. This more accurately divides up the cylinders when using the pressure sensor.
    • Added Demo Mode button/inidcator to Main tab.
    4/25/2007: Rev 1.02:
    • Added several videos to setup wizard.
    • Added multiple ? Help buttons and help text tab for quick access to EScope Limited help. Also changed manual to Flash type.
    • Fixed scaling factor on 20" H20 pressure sensor.  Previous scaling only showed half of actual pressure.
  • 03/21/2006: Rev 1.01:
    • Initial release.

Driver Download (only needed if first installation):

  • Go to ftp://ftp.ni.com/support/daq/pc/ni-daq/daqmx/8.6/
    • Read install.txt installation directions.
    • Download NIDAQ860.exe. File size is over 800MB so download may take a while!
    • Notes:
      • This driver version supports Windows XP and VISTA for all EScopes.
      • This driver will also install the VISA driver used by the EScan and Emission programs that is required by VISTA.
      • The VISTA driver does not support the PCMCIA card used on the original EScope (only the EScope Limited and EScope Pro can be used on VISTA).
      • Do not install an NIDAQ driver older than 8.5.0 on VISTA
 
Sales: sales@automotivetestsolutions.com / Support: support@automotivetestsolutions.com
Suggestions: suggestions@automotivetestsolutions.com
Copyright © 2002-2009 Automotive Test Solutions, Inc.
Phone: 505-265-5077, Toll-Free: 800-572-6112, Fax: 866-422-2931
515 Wyoming SE Suite A, Albuquerque, NM 87123