EIgnition Download and Installation of latest version - Rev 1.12:

Checking your software version:
To see what version you are currently using load your EIgnition software, click on the "Help" tab and then click the "About" text in the upper left hand corner of your screen.

The EIgnition program will only run if you have the ATS EScope or EScope Pro hardware.

• Download http://www.automotivetestsolutions.com/download/EIgnitionInstall.zip (~17MB)
• Download the above link to a temporary folder on your hard drive and Unzip the file.
• Run Setup.exe to install the EIgnition. If the installer asks you if it is OK to uninstall the existing version allow it to and then run the Setup.exe again to install the new version.

Revision History (most recent version can be downloaded above)

• 9/23/2007: Rev 1.12:
  • Changed chart history length from 10000 to 50000 points.
  • Changed manual to Flash based manual.
  • Added ‘?’ help buttons.
  • Setup automated detection of EScope or EScope Pro interface.
  • Added Demo Mode button/indicator on main tab.
  • Fixed problem where Demo Mode would automatically get selected at startup or auto-restart if interface board was not seen.
  • Pop-up will now allow user to see error and re-start or select demo mode.
    Added faster Maximum Sample Rates displayed if using EScope Pro.
• 8/30/2006: Rev 1.11:
  • First version posted on this update page.